![]() Type ‘make clean’ and ‘make’ in the directory of the makefile. The most obvious thing to change is the CCD clock. Download the TCD1304-driver firmware for the STM32F103 and unzip to the directory the USB-library was extracted to.Proceed with the default binary settings on the first page: On then next page select the ARM toolchain. ![]() (mini) USB connector is used to power the Xnucleo board, the host PC will. Select File->New->Project and select the Embedded Project Wizard from the VisualGDB wizards. Download and unzip the USB full speed device library (UM0424) STM32 Development Board, Supports Arduino, Compatible with NUCLEO-F401RE.Uint16_t (*pIf_DataTx) (uint8_t* Buf, uint32_t Len) Change the declaration of *pIf_DataTx from ![]() ~/STM32_USB-Host-Device_Lib_V2.2.0/Libraries/STM32_USB_Device_Library/Core/src/usbd_core.c In this case the USB peripheral behaves as as USB HOST. You can also use it to read contents of a flash drive (thumb drive) connected to USB interface of the STM32F401RE. ~/STM32_USB-Host-Device_Lib_V2.2.0/Libraries/CMSIS/Device/ST/STM32F4xx/Include/stm32f4xx.h The storage media is a SD (or microSD) card connected with SDIO peripheral.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |